Henny Penny FS-200 - Manual (Page 5)

FS-100/200
Optional Pouring Spout Extension Installation
1. Remove nuts and taped brackets from the extension as shown
in Figure 1.
2. Lay the Shortening Shuttle TM flat on the floor or table.
3. Leaving the small bracket on the threaded studs (Figure 2)
spread the extension out and fit it over the spout of shuttle.
Make sure the small bracket rests on the edge of the spout,
and gasket fits along the top edge of the spout.
4. Determine which set of threaded stud the larger brackets
fits. The brackets have a slight bow to them and must be
installed on the correct side. The bend goes towards the
inside of the shuttle.
5. Fit the larger brackets over the threaded studs. Make sure the
notch in the larger bracket rests against the edge of the spout.
Figure 3.
6. Thread the nuts (previsously removed) onto the threaded
studs and tighten with a 7/16” wrench or socket. When the
nuts are tightened, the lower part of the bracket squeezes the
spout of the shuttle, securing the extension in place. Figure 4.
The brackets and extension may need squeezed together with
pliers or vise-grips to allow enough threads to show through to
start nuts on threads of studs.
7. Shortening Shuttle TM is now ready for use.
2
Figure 1
Figure 2
Figure 3 Notch Figure 3
Figure 4