Honeywell HD28D4HR6 - Manual (Page 8)

Rev 1.01 3 Document 900.0275
10/05
Installing the Conduit Plug
Your HD28 enclosure comes with a conduit plug pre-installed in the 1/2” conduit
entry on the back of the housing. This plug may be removed and installed in the
side 3/4” conduit entry (see
Figure 2 ).
Figure 2 Conduit Plug Installation
Caution If a conduit is not used for cable routing, install the rubber
grommet in the conduit hole, then slit the grommet and feed
the wiring through. Seal the grommet to prevent moisture from
entering the housing.
Back View Side View
Screw
Retainer plate
Gasket
Conduit plug