Hilti WSC 70-A36 - Manual (Page 8)

The use of saw blades that do not comply with the given specification (e.g. diameter, thickness) or the use of
cutting and grinding discs or blades made from high-alloy steel (HSS steel) is not permissible.
Sawing metals is not permissible.
Do not use the power tool to cut tree branches or logs.
Do not use the battery as a power source for other unspecified appliances.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2.2 Switches
Control switch with switch-on interlock
2.3 Grips
Grip and auxiliary grip
2.4 Protective device
Blade guard and pivoting guard
2.5 Lubrication
Grease lubrication
2.6 Deep discharge protection
To extend the life of the battery and the motor, the electronic control system is designed to audibly reduce
blade drive speed when excessive pressure is applied, up to the point at which the blade stalls completely
when pressure is maintained causing activation of the power cut-out.
CAUTION
So long as the control switch remains depressed, the power tool runs up to speed again when the pressure
applied to it is released, just like a mains-powered tool.
2.7 Li ತion battery charge status
When a Li-ion battery is used, the charge status can be indicated by gently pressing one of the battery release
buttons (press until resistance is felt - do not release the battery). The display on the rear of the battery
provides the following information:
LEDs light constantly LEDs blink Charge status C
LED 1,2,3,4 - C ฺ 75 %
LED 1,2,3 - 50 % ู C < 75 %
LED 1,2 - 25 % ู C < 50 %
LED 1 - 10 % ู C < 25 %
- LED 1 C < 10 %
2.8 Items supplied as standard
1 Power tool
1 Saw blade
1 Hexagon socket wrench
1 Operating instructions
1 Hilti toolbox (optional)
1 Cardboard box (optional)
en
19