Holmes HFH5505 - Manual (Page 2)

Manual Mode Instructions:
1. Plug the heater into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for the HIGH
(1500 Watts) manual setting. (See fig. #1 and #2)
3. Press the button again for the LOW (1000 Watts) manual setting.
(See fig. #1 and #2)
4. To stop the unit, press and hold the button for two seconds or keep
pressing the button until all the temperature indicators are OFF.
Note: The Power Light will remain lit during operation. In
Manual Mode, only the LOW or HIGH power light will be lit.
1 Touch Thermostat Instructions:
To take advantage of the 1 Touch
™ Thermostat continue to press the
MODE/OFF button until the desired temperature is set in either the HIGH
(1500 Watt) or LOW (1000 Watt) setting. When ambient temperature
rises above the set temperature, the heater will stop. When the ambient
temperature drops below the set temperature, the heater will turn on
automatically.
Note: When the 1 Touch™ thermostat is set, either the HIGH
or LOW power light, and the set temperature light will remain
lit during operation. (See fig. #1 and #2)
Note: It is normal for the heater to cycle ON and OFF
as it maintains the preset temperature. To prevent the
unit from cycling, you need to raise the thermostat setting.
Note: 1 Touch™ has memory. The 1 Touch™ thermostat
will remember the previous temperature setting after the
unit has been turned off. However, if the unit is unplugged,
the 1 Touch™ thermostat will be reset and will no longer
remember the previous temperature setting.
OSCILLATION INSTRUCTIONS
1. Select the desired control setting and press the oscillation button ON.
2. To stop oscillation, press the oscillation button again.
3. Please do not manually turn the unit, it is designed to turn only
by motorized oscillation.
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild soap solution.
3. NEVER use abrasive or flammable solvents to clean the unit.
4. After cleaning, be sure to completely dry the unit with a cloth
or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. Holmes recommends that you store the unit in its original carton.
TROUBLESHOOTING
If your heater fails to operate:
• UNPLUG THE UNIT.
• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn the heater
OFF, and unplug the unit. Carefully remove the obstruction and
follow the reset instructions.
• The temperature may be set too low. Press the MODE/OFF button
until the heater restarts.
If your heater fails to oscillate:
• Make sure the oscillation button is pressed.
• Make sure nothing is wedged between base and body.
Please DO NOT attempt to open or repair the heater. Please
see the Warranty for Service Instructions
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1) Read all instructions before using the appliance.
2) To avoid fire or shock hazard, plug the appliance directly into
a 120 V AC electrical outlet.
3) The heater is hot when in use. To avoid burns, DO NOT let bare skin touch
hot surfaces. If provided, use handles when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes,
and curtains at least 3 ft (0.9 m) from the front of the heater and keep
them away from the sides and rear.
4) DO NOT run cord under carpeting. DO NOT cover cord with throw rugs,
runners , or the like. Arrange cord away from traffic area and where
it will not be tripped over.
5) This heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. NEVER locate heater where it may fall into
a bathtub or other water container.
6) Extreme caution is necessary when any heater is used by, or near children
or invalids, and whenever the heater is left operating and unattended.
7) Always unplug the heater when not in use.
8) When unplugging, be sure to pull by the plug and not the cord.
9) DO NOT insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
10)DO NOT operate heater with a damaged cord or plug, or after the heater
malfunctions, has been damaged in any manner. Return appliance
to manufacturer for examination, electrical or mechanical adjustment,
or repair.
11)A heater has hot and arcing or sparking parts inside. DO NOT use it
in areas where gasoline, paint, or flammable liquids are used or stored.
12)Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons. The use of attachments
not recommended or sold by The Holmes Group may cause hazards.
13)DO NOT use outdoors.
14)To prevent a possible fire, DO NOT block air intakes or exhaust in any
manner. DO NOT use on soft surfaces, like a bed, where openings may
become blocked.
15)To disconnect heater, press MODE/OFF for two seconds, then remove plug
from outlet.
16)Avoid the use of an extension cord because the extension cord may
overheat and cause a risk of fire. However, if you have to use an
extension cord, the cord shall be No. 14 AWG minimum size and rated
not less than 1875 watts.
17)If the heater will not operate, see specific instructions on Auto Safety
Shut-off.
18)DO NOT attempt to repair or adjust any electrical or mechanical functions
on this unit. Doing so will void your warranty. The inside of the unit
contains no user serviceable parts. All servicing should be performed
by qualified personnel only.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
AUTO SAFETY SHUT-OFF WITH
CERAMIC CONTROL
This heater is equipped with a patented, technologically-advanced safety
system that requires the user to reset the heater if there is a potential
overheat situation. When a potential overheat temperature is reached,
the system will automatically shut the heater off. It can only resume
operation when the user resets the unit.
To Reset the Heater:
1. Unplug the Unit.
2. Wait 10 minutes for the unit to cool down.
3. After the 10 minutes, plug the unit in again and operate normally.
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box.
(please save the carton for off-season storage).
2. Place heater on firm level surface.
3. Avoid overloading your circuit by not using other high wattage
appliances in the same outlet. At 1500 Watts, this unit draws
12.5 Amps.
OPERATING INSTRUCTIONS
Your heater is equipped with a technologically advanced 1 Touch ™
electronic thermostat. You can set the heater to run continuously
in manual mode or set the 1 Touch ™ thermostat to your desired
temperature setting. The 1 Touch ™ thermostat will automatically
turn the heater ON or OFF depending on the preset comfort level.
The comfort level ranges between 60º and 80º Fahrenheit.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current) PLUG (a plug having one blade wider
than the other). This plug will fit into the power outlet
only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact qualified
personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
/Off
FIGURE 1
A. MODE/OFF BUTTON
B. HIGH POWER (1500 WATTS)
C. LOW POWER (1000 WATTS)
D. SET TEMPERATURE LIGHT
E. OSCILLATION BUTTON
C
D
A
B
/Off
FIGURE 2
A. MODE/OFF BUTTON
B. POWER LIGHTS
C. SET TEMPERATURE
LIGHTS
D. OSCILLATION BUTTON
E. OSCILLATION BASE
F. CARRY HANDLE
(NOT VISIBLE)
C
D
A
B
E
E
™
™
F