HoMedics PerfectSteam PS-250 - Manual (Page 6)

10 11
Trouble Shooting the Steamer NOTE:
1. Water mineral content and conditions will vary in different areas. To insure continued
operation of the steamer, never store without cleaning and removing excess water from the
reservoir and water container.
2. If the reset light comes on with water in the tank you probably need to remove mineral build-
up.
3. In areas where the voltage exceeds 120V, it may be necessary to clean your unit more
frequently.
PROBLEM CAUSE SOLUTION
Steamer fails to heat Steamer not plugged in
ON/OFF switch not in
“ON” position
Auto shut off engaged
Plug in to electrical outlet
Push switch to “ON”
position. Switch will
illuminate.
Check water container to
ensure it is not empty. If
full, press the reset button
on side of unit. If empty,
refill and push reset to
begin.
No steam Water level is low Turn ON/OFF switch OFF
and refill water container
Water drips from nozzle Condensation in hose Hold the hose vertically
and allow water to drain
back into tank
Nozzle gurgles Condensation in hose Hold the hose vertically
and allow water to drain
back into tank
Steam is intermittent Mineral build-up Follow the procedure for
removing mineral build-up