haier AP602AKEAA - Manual (Page 12)

Timer ON/OFF Function
Set clock correctly before starting TIMER operation
1.Unit start
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
ON OFF ON OFF
AM 12:00 AM 12:00
PM
12:00
PM
12:00
TIMER ON TIMER OFF TIMER ON-OFF
blank
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
Now or will flash.
4.Confirm setting
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode
disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting must be reset.
Remote controller has memory function. When you use TIMER mode next time, just press SET
button after mode selection if timer setting is the same as the previous one.
Note:
After setting TIMER function, the remote controller displays TIMER time.
ON OFF
ON OFF
After setting correct time, press SET button to confirm time. Now
or stop flashing.
Every time the button is pressed, time increases 1 minuts.
If the button is kept pressed, time changes quickly.
3.TIMER setting (press time adjust buttons )
Every time the button is pressed, time decreases 1 minuts.
If the button is kept pressed, time changes quickly.
It can be adjusted within 24 hours at will.
Manual Operation
10
Operation
Remote controller
The control panel will display TIMER.
Control panel
ON
OFF
TEMP
HEALTH FAN
MODE
SLEEP SWING
CLOCK
TIMER
SET
LOCK LIGHT RESET
HEAT
1
ON
ON/OFF MODE FAN
TEMP
TEMP+ TEMP- HEALTH TIMER