Hyundai A2054-326 - Manual

HYUNDAI S COUPE 1.5i MVi 1992 - 95 57-0263 Instruction Sheet A2054-326
Page 1 of 2
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE FITTING THE KIT.
Photo A
Photo B
Instruction sheet A2054-326
Page 2 of 2
Your car and the engine bay should look like the ones
in these pictures, if not then talk to your kit supplier.
Should you still have a problem, call K&N customer
services. Tel: 01925-629609. Fax: 01925-629610.
1. Unclip and remove
the intake hose from
the MAS (Mass Air
Sensor).
Photo C
2. Unclip and remove
the air box lid
assembly and filter
element from the air
box base.
3. Remove the air box
base from the inner
wing by removing the
3 securing screws
located inside of the
air box base.
1. Fit the new filter onto
the MAS. Tighten the
clip until the filter just
turns, Rotate the filter
until the K&N logo is
straight then tighten the
clip one full turn (360
degrees) no more, Do
not overtighten the
clip.
2. Attach the new
bracket to the rear air
box mounting point
located on the inner
wing using an original
mounting screw.
3. Attach the stud on
the filter lid to the
bracket using a nut, flat
washer and spring
washer supplied.
4. Carefully lengthen
the flexi cold air hose
to approx. 76cm / 30”
and feed it down past
the side of the radiator
to the front lower grille.
5. Pierce a hole in the
top of the flexi cold air
hose and attach the
hose to the middle air
box mounting point
using a plastic tie
supplied. Position the
end of the flexi cold air
hose to finish 10cm /
4” from the filter no
nearer.
10cm / 4”
no nearer