HoMedics PED-100 - Manual (Page 2)

On-Off Switch
Attachment
Give Your Feet The Attention They Deserve
Thank you for purchasing the Sole Mate Portable Pedicure Kit. This pedicure kit is built
with high quality craftsmanship to ensure years of dependable use.
IMPORTANT SAFETY INSTRUCTIONS:
• Unit should never be used in the presence (direct or indirect) of any liquids. The Sole
Mate Portable Pedicure Kit is not waterproof, and will short circuit when in contact
with liquids. This includes areas of extreme humidity (i.e. bathroom), where corrosion
can take place.
• Avoid exerting strong pressure on the massage head. Never dropor strike the unit
against a hard surface.
• Dead batteries should be immediately removed from the battery compartment, as
they will leak and corrode the internal contacts.
WARNING
-
Caution – Please read all instructions
carefully before operating.
• Close supervision is mandatory when this appliance is used by, on or near children,
invalids or disabled persons.
• For health and safety reasons, avoid usage of product directly over any sensitive or
irritated areas.
• Individuals with any previous medical conditions should refrain from using this product.
• This product is intended for hand-held, intermittent use and should be operated for
no more than 30 minutes at a time. For best results, unit should be used for short
periods of 5 to 10 minutes.
MAINTENANCE
• Never use benzene, thinners, or any other organic solvents to
clean the product. Use of these cleansers will damage the unit.
• Only a damp cloth should be used to clean the pedicure unit and
its attachments.
To Apply Attachments:
1. Select the attachment you wish to use. (See Figure 1.)
2. Secure the attachment to the Sole Mate unit. (See Figure 2.)
For Battery Insertion:
1. Remove the battery cover in the direction of the arrow. (See Figure 2.)
2. Insert 2 “AA” batteries (not included) into the compartment.
Once complete replace battery cover.
DO NOT MIX OLD AND NEW BATTERIES, DO NOT MIX ALKALINE,
STANDARD (CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADIUM)
BATTERIES.
How to Turn Off and On:
1. Locate the on/off switch on the side of the Sole Mate unit.
(See Figure 2.)
2. Push the switch to the ‘I’ position to turn on.
3. Push the switch to the ‘O’ position to turn off.
2 3
Coarse
Medium
Fine
2 ‘AA’ batteries
(Not included)
Battery Cover
Figure 1
Figure 2