Installing the ribbon – HP T3304 User Manual
Page 25
Media
Supply
Window
Media
Supply Door
Printhead
Latch
Hinge
Plate
Installing the Ribbon
17
Operator’s Guide
As noted previously, when printing in thermal
transfer mode, the printer requires a ribbon.
Use the following procedure to install a new
ribbon.
note
The thermal transfer mode is selected
through the printer menu system. The main
menu is accessed via the secondary
operator panel. Refer to the “Configuring
the Printer” chapter in the
Setup Guide
for
complete instructions in how to access and
use the secondary operator panel.
1
Press ON LINE/PAUSE to place the
printer in the off line mode.
2
Open the media supply door.
3
Rotate the printhead latch
counterclockwise to unlatch, and raise
the printhead.
Lower the hinge plate.
4
Place the new ribbon supply roll on the
supply hub.