Hitachi HPW-200EC User Manual
Page 51
50
S11 - DTMF Tone Duration
Sets the duration of tones in DTMF dialing. This value has no effect on pulse dialing.
Range:
50-255 milliseconds
Default:
95 (95 milliseconds)
S12 - Escape Guard Time
Defines the guard time for the escape sequence, in fiftieths of a second.
Range:
0-255 1/50ths of a second
Default:
50 (1 second)
S36 - LAPM Failure Control
This value indicates what should happen upon a LAPM failure. If an invalid number is entered, the number
is accepted into the register, but S36 will act as if the default value has been entered.
0
=Modem disconnects
1
=Modem stays on-line and a Normal mode connection is established
2
=Modem stays on-line and a Normal mode connection is established
3
=Modem stays on-line and a Normal mode connection is established
4
=Modem disconnects
5, 6 =Reserved
7
=Modem stays on-line and a Normal mode connection is established (default)
S37 - Desired Line Connection Speed
This register specifies the desired line connection speed.
Default: 0
Desired line connection speed. This is interlinked with the Fn command . If an invalid number is entered,
the number is accepted into the register, but S37 will act as if the default value has been entered.
0 = Attempt automode connection (default)
1-3 = Attempt to connect at 300bps. F1 command
4 = Reserved
5 = Attempt to connect at 1200bps. F4 command
6 = Attempt to connect at 2400bps. F5 command
7 = Attempt to connect at V.23. F3 command
8 = Attempt to connect at 4800bps. F6 command
9 = Attempt to connect at 9600bps. F8 command
10 = Attempt to connect at 12000bps. F9 command
11 = Attempt to connect at 14400bps. F10 command
12 = Attempt to connect at 7200bps. F7 command
13 = Attempt to connect at 16800bps
14 = Attempt to connect at 19200bps
15 = Attempt to connect at 21600bps
16 = Attempt to connect at 24000bps
17 = Attempt to connect at 26400bps
18 = Attempt to connect at 28800bps
20 = Attempt to connect at 33600bps