Setup – Harbor Freight Tools 95834 User Manual
Page 5
Page 5
SKU 95834
For technical questions, please call 1-800-444-3353.
SEtUp
For best service you should incorporate a regulator and inline filter on the com-
pressor end of the hose, as shown in the diagram above. Hoses, couplers, regulators,
and filters are all available at Harbor Freight Tools.
You will need to prepare a
1.
1
/
4
” air connector (not included) to connect to the Elbow
Fitting (8) on the tool. First, wrap the
1
/
4
” air connector with pipe thread seal tape
before threading it into the Elbow Fitting. Connect the
3
/
8
” ID Air Source Hose to a
quick connect coupler (not included), and then to the tool.
Set the air pressure on the regulator near the compressor to 90 PSI.
2.
do not ex-
ceed the maximum air pressure of 100 pSI.
Check the air connection for leaks. Disconnect from the air source.
3.
to cLEAn thE FUEL InjEctoRS
Run the vehicle’s engine outside until it reaches normal operating temperature.
1.
Then, shut off the engine.
Disable the vehicle’s fuel pump.
2.
note: It is best to unplug the fuel pump at the fuel tank. On some vehicles, pulling the
fuel pump fuse also disables the ignition system or fuel injectors.