Husqvarna 323P4 - Manual (Page 3)

English – 3
CONTENTS
Contents Note the following before starting:
The machine is only designed for cutting branches and twigs.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
Husqvarna AB has a policy of continuous product
development and therefore reserves the right to modify the
design and appearance of products without prior notice.
This decal certifies that the product has been approved in
accordance with American exhaust emissions requirements
EPA Ph II and CARB Tier II. The Emissions Compliance
Period referred to on the Emissions Compliance label
indicates the numbers of operating hours for which the engine
has been shown to meet Federal and California emission
requirements.
KEY TO SYMBOLS
Symbols ....................................................................... 2
CONTENTS
Contents ...................................................................... 3
Note the following before starting: ................................ 3
SAFETY INSTRUCTIONS
Personal protective equipment ..................................... 4
Machine
′
s safety equipment ........................................ 4
Checking, maintaining and servicing the machine
′
s
safety equipment .......................................................... 5
General safety precautions .......................................... 11
Safety instructions for using a pruning saw ................. 12
WHAT IS WHAT?
What is what? .............................................................. 15
ASSEMBLY
Fitting the cutting head ................................................ 16
Fitting the bar and chain .............................................. 16
Adjusting the harness .................................................. 16
Filling with oil ................................................................ 16
Assembling and dismantling the two-piece shaft
(325P5) .........................................................................
17
FUEL HANDLING
Fuel .............................................................................. 18
Fuelling ........................................................................ 18
STARTING AND STOPPING
Check before starting ................................................... 19
Starting and stopping ................................................... 19
MAINTENANCE
Carburettor ................................................................... 20
Muffler .......................................................................... 21
Cooling system ............................................................ 22
Spark plug .................................................................... 22
Air filter ......................................................................... 22
Bevel gear .................................................................... 23
Maintenance schedule ................................................. 23
TECHNICAL DATA
Technical data .............................................................. 24
FEDERAL EMISSION CONTROL WARRANTY
STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS ..... 26
!
WARNING! Under no circumstances may the
design of the machine be modified without
the permission of the manufacturer. Always
use genuine accessories. Non-authorized
modifications and/or accessories can result
in serious personal injury or the death of the
operator or others.
Your warranty does not cover damage or
liability caused by the use of non-authorized
accessories or replacement parts.
IMPORTANT ENGINE INFORMATION
HUSQVARNA AB HUSKVARNA SWEDEN
TWC
REFER TO OPERATOR`S MANUAL FOR
MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.
FOR SMALL NON - ROAD ENGINES.
EP THIS ENGINE CONFORMS TO U.S. PH1 A