Heath Zenith All MetAl Motion SenSor HD-9260 - Manual (Page 7)

-- 598-1188-02
Controlling Non-Motion Sensing Fixtures
❒ When wiring to additional standard fixture
only: Strip the motion sensor's red wire and
connect to the standard fixture's
black wire.
Connect all white wires together. Total fixture
ratings must not exceed 1000 Watts (8.3 A).
NOTE: All wiring between fixtures should be run
in accordance with the National Electrical
Code (Canadian Electrical Code in Canada)
through conduit or another acceptable means.
Contact a qualified electrician if there is any
question as to the suitability of the system.
❒ This fixture is provided with a sensor rated
for 1000 Watts. Since the fixture is only rated
500 Watts, 500 Watts of additional load may
be controlled by this sensor.
❒ When determining what a fixture is rated for,
do not simply look at the rating on the lamp in
the fixture. Look at the marking which speci-
fies the maximum lamp wattage for which the
fixture is suitable.
❒ Once you have selected the fixtures to be con-
nected and determined their maximum ratings,
add these ratings up. For instance, if you have 3
fixtures rated 100 Watts, 150 Watts, and 75 Watts
respectively, you have a total load of 325 Watts.
Wiring to a Motion Light & Standard Fixture
Standard
Fixture
RED from JourneyMan ® to
BLACK from Fixture
BLACK from Switch to
BLACK from JourneyMan ®
WHITE from Line
to WHITE from
JourneyMan ®
WHITE from Line to
WHITE from Fixture