Honeywell HZ-7200 - Manual (Page 2)


OPERATION
Do not use it in the areas where gasoline, paint or
flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any
other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
17. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated
not less than 1875 watts.
18. Never tamper with this product or attempt to fix it.
Any tampering with, or modification of, this product
can result in serious injury, death, or fire. Risk of
electric shock. Do not open, no user serviceable
parts inside.
19. Do not remove product labels that contain warnings
or safety instruction.
20. The output of this heater may vary and its
temperature may become intense enough to burn
exposed skin. Use of this heater is not recommended
for persons with reduced sensitivity to heat or an
inability to react to avoid burns.
21. Before cleaning, or storage, or when not in use, turn
the fan to the off position and unplug the heater
from the electrical outlet.
22. Place the heater on a firm, level, open surface free
from obstructions and at least 3 feet (0.9 m) away
from any combustible materials. DO NOT use on an
unstable surface such as bedding or deep carpeting.
Be sure the heater is not in a position where it
may be tripped over by small children or pets. The
heater’s rubber feet will hold it firmly in position.
23.
SAVE THESE INSTRUCTIONS
• Place the heater on a firm, level, open surface free from
obstructions and at least 3 feet (0.9 m) away from any
combustible materials.
• Never leave an operating unit unattended.
• Plug the heater into an electrical wall outlet.
• Touch the power button ( ) to turn the heater on.
The power indicator light will illuminate. Fig. 1
• To save up to 35% in energy bills, turn the Energy
Smart™ knob to your desired temperature. There are four
distinct settings of 65°F/18°C, 70°F/ 21°C, 75°F/23°C, and
80°F/26°C. The Energy Smart™ heater will automatically
select the appropriate power level to best accommodate
your desired temperature. As the air temperature in
the room approaches the set temp, the heater will
automatically lower the power consumption and provide
consistent warmth without wasting energy.
• The illuminated LED lights will indicate what the current
room temperature is.
• This heater is equipped with a “frost watch” which automatically turns the unit on if the temperature drops below 55°F/12°C
degrees to help protect against freezing pipes or frost damage
• To override the Energy Smart™ feature and produce maximum heat, turn the knob fully clockwise to “High”. This will
produce 1500W of heat at all times.
• To turn on the oscillation feature, press the ( ) button once. To turn it off, press the ( ) button once more. Please note,
the oscillation function will stop when the Energy Smart™ mode has reached the desired temperature and the heater is no
longer blowing warm air. It will start back up when the heater starts blowing warm air again.
Fig. 1
Power
Button
Control Knob
Oscillation
Button
Power Indicator Light