Harbor Freight Tools 32650 - Manual (Page 21)

Page 21 For technical questions, please call 1-800-444-3353. SKU 32650
Figure 28
Belt (34)
Spindle
Pulley
(38)
Motor
Pulley
(3e)
Bolts
(35)
Motor
Bracket
(36)
Bolts
(35)
5. Remove the old Belt (34) and place a
new belt on the Pulleys (3e and 38).
If the tension needs adjusting:
6.
Loosen the four hex head Bolts (35) on a.
the Motor Bracket (36).
Slide the bracket up or down until the
b.
sides of the belt are tight.
Tighten the bolts and make sure the belt
c.
runs straight.
nOTe: Never over-tension belt as this will
result in shortened motor bearing life.
Replace the belt guard and turn the
7.
machine right side up.
carbon Brush replacement
Replacement Carbon Brushes (3b)
are included with this unit. The Carbon
Brushes should be replaced by a
qualified technician.
reV 10e