English – Heath Zenith Lighting Controls 598-1306-02 User Manual

Page 7

Advertising
background image

7

598-1306-02

ENGLISH

6. Set desired DIM level. Note: DIM setting remembers last

setting used. To recall last DIM setting from ON or OFF, push
and release either the top or bottom of DIM button.

Note: The DIM setting defaults to 50% in the event of a power
failure.

Bulb replacement

Move the power disconnect switch to the OFF (left side) position.
Replace bulb(s).

CautIoN: do not exceed the maximum load limits

listed above.

operation

1. Verify the power disconnect switch is in the ON (right side)

position.

2. Push the ON (top) button and release. The light should turn on

full bright. Note: If you are controlling a lamp, make sure it is
connected to the switched outlet and the lamp is switched on.

3. Push the OFF (bottom) button and release. The light should

turn off.

4. Push either the top or bottom of DIM button and release. The

light should turn on at 50% brightness (or last setting).

5. Push and release top of DIM button to increase brightness.

Push and release bottom of DIM button to decrease bright-
ness. Note: There are 5 DIM settings ranging from 15% to 90%
brightness.

Advertising