Heath Zenith Dual Brite PF-4144-AZ - Manual (Page 7)

7 598-1166-03
SPECIFICATIONS
Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
[varies with surrounding
temperature].
Sensing Angle . . . . . Up to 150°, 240°
adjustable
Electrical Load . . . . . See rating on fixture
for maximum wattage
Sensor Capacity . . . Up to 360 Watts (3.0
A.) Maximum
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
MANUAL MODE
Time Delay . . . . . . . 1, 5, 10 minutes
D
ual
B
rite
® Timer . . . 3, 6 hours, dusk-to
dawn
DESA Specialty Products reserves the
right to discontinue products and to change
specifications at any time without incurring
any obligation to incorporate new features
in products previously sold.
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
POSSIBLE CAUSE
1. The sensor is pointed at nearby
objects that cause heat to trigger
the sensor. (Aim the sensor
away from nearby objects.)
2. The sensor is pointed toward
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Re-
aim sensor.)
1. Heat being reflected from other
objects may be affecting the
sensor. (Re-aim sensor.)
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this
is a new installation.
6. Re-aim the sensor to cover
desired area.
1. Light Control may be installed
in a relatively dark location.
2. Light Control is in Test. (Set
control switch to an ON-TIME
position.)
1. Light Control may be sensing
small animals or automobile
traffic (re-aim sensor).
2. Sensitivity is set too high.
(Reduce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes
on in daylight.
Light comes
on for no ap-
parent reason.
TROUBLESHOOTING GUIDE