Haan Total HD-60 - Manual (Page 11)

9
IMPORTANT: Vibration Sound
IMPORTANT
While the unit is turned off, air builds up in the water pump
line. This is a common occurrence. When the unit is turned on
the water pump pushes air out of the line and emits a vibrating
sound. This occurs while the unit is heating up and also when
the water tank is emptied during use. If the vibration sound
persists for more than 60 seconds during heat up, check to make
sure the water tank is assembled correctly.
Always empty the water tank once you have finished using your
Floor Sanitizer.
To turn Sweeper Brush ON/OFF,
gently press the “Brush ON/OFF”
button located on the back of the
unit.
7
10
Tilt handle at a 45º angle. Push
and pull slowly across the floor
to clean thoroughly.
When unit has cooled, remove
Ultra-microfiber pad. Store
unit upright in a dry area.
8
When done, push ON/OFF button.
9
Place unit with Ultra-microfi-
ber pad attached onto Floor
Protector / Resting Mat. Allow
to cool down for five (5) min.
POWER
STEAM
Using the Sweeper Function
Helpful Hint:
When cleaning floors the
steam function and sweeper
function can be used at the
same time.