Harbor Freight Tools 42827 User Manual
Page 2
SPECIFICATIONS
INCLUDED ACCESSORIES
5 and 6mm Hex Wrenches
Draw Bar
R-8/JT2 Chuck
14 / 17mm Open End Wrench
Slotted Screwdriver
Head Wrench
FEATURES
1.
This machine may be used for surface cutting, drilling, milling, and tapping.
2.
The high quality of this machine, and its ease of operation makes it suitable for use by students,
amateurs, and home hobbyists, as well as skilled technicians.
3.
Drilling and milling may be done using hand operated feeding, or worm-gear feeding.
4.
Many of the adjustable nuts are bronze, for adjusting thread clearance and reducing wear. These
bronze parts also allow screws to rotate smoothly and improve accuracy.
5.
The vertical column is very strong and stiff, which makes the machine very stable and improves
accuracy of manufactured parts.
6.
The machine head is cast steel, and has been heat-treated, stress-relieved, and precision machined.
7.
Machine gears are precision ground for smooth operation.
8.
Speeds can be easily changed.
9.
Thread tapping operations can be done in either rotation, and working depth can be controlled using a
positive stop gauge.
Page 2 SKU # 42827
SAVE THIS MANUAL
You will need the manual for the safety warnings and cautions, assembly instructions, operating procedures,
maintenance procedures, trouble shooting, parts list, and diagram. Keep your invoice with this manual.
Write the invoice number on the inside of the front cover. Keep both this manual and your invoice in a safe,
dry place for future reference.
NOTICE
The Warnings, Cautions, and Instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
Motor:
110V/60Hz Single Phase
1.5 HP, 15 Amps
6 Speeds (rpm):
95-175-310-450-850-1500
Motor rpm’s:
1720
Spindle Taper:
R8
Spindle Collar:
1.740”
Spindle Stroke:
5”
Spindle to Table:
17-3/4”
Drill Cap:
1-1/4”
Face Mill Cap:
3”
End Mill Cap:
3/4”
Tapping Cap:
1/4”
Max. Y-Travel:
6-13/16”
X-Travel:
19-13/16”
Table Dimensions:
27-1/2”L x 9-1/2”W
REV 11/06