High End Systems AF1000 - Manual (Page 21)

Chapter 2 Mini Controller Operation 2-3
2
Program Hold
Program Hold allows another program to be selected without affecting the
current program being run. Program Hold is initiated by holding down the
<
program > key and using the arrow keys to pre-select another program. The
Program Hold Indicator (LED between the 7-segment LEDs in the value
display) will illuminate to confirm this mode is active. The next program
will not begin until the <
program > key is released.
Program Select Return
Twelve seconds after adjusting the Rate, Intensity, or Audio setting, the controller
will return to Program Mode. Any changes made to the above settings will be in
effect.
Standard Programs
The number of Standard Programs the Mini Controller can use depends on the
number of channels that are set up. Refer to Table 2.1.
Table 2.1: Standard Programs Per Channel
Number of
Channels
Number of
Programs
1 6
2 12
3 24
4 23
5 27
6 27
7 27
8 27
9 27
10 27
11 27
12 27