Helio PN-810 - Manual (Page 8)

BATTERY USAGE BEFORE USING
■ BATTERY INSTALLATION
As shown in the picture below, put the metal locators of the
battery into the holes located in the bottom of the unit.
Place the battery on the back of the handset and
slide into place.
Push the battery down until it locks into place.
15
If the battery is not correctly placed in the compartment,
the handset will not turn on and/or the battery may be
detached during use.
BEFORE USING BATTERY USAGE
14
■ BATTERY REMOVAL
Pull up the release latch, lift up the battery.
Remove the battery from the handset.
ᕡ
ᕢ
ᕡ
ᕢ
■ BATTERY CHARGING
POWER CONNECTION
Plug the AC Charger into a standard outlet.
Plug the other end of the AC Charger into the
bottom of your phone. The battery must be
installed onto the phone.
• You cannot operate the phone until it is powered on.
• Fully charge the battery before use.
• It is more efficient to charge the battery with the handset
powered off.
• The battery must be connected to the phone in order to
charge it.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to
replace the battery.
ᕡ
ᕢ