Philips HI558 - Manual (Page 9)

9
- Put the iron back on its stand. Let it heat up
again until the amber pilot light goes out.
- Remove the iron from the stand and move it
over a (preferably) old piece of cloth.
This is to ensure that the soleplate will be dry
during storage.
- Unplug and allow the iron to cool down before
storing it on the stand.
Cleaning
- Before cleaning remove the mains plug from
the wall socket and allow the iron to cool down
sufficiently.
- Scale and other setting can be wiped off the
soleplate with a damp cloth and some non-
scratching (fluid) abrasive.
Keep the soleplate smooth: avoid hard
contact with metal objects.
- The upper part of the appliance can be cleaned
with a damp cloth.
- From time to time clean the inside of the water
reservoir by filling with water and shaking.
Then pour the water back out.
Storage
• Always store the iron on the stand to prevent
damage to the soleplate.
- Remove the mains plug from the wall socket.
- Set the steam control
(B) to position O (= no
steam).
- Set the 3-positions
switch to position ∫
(fig. 27).
- Take the iron from the
stand. Open the filling
funnel and pour the
remainder of the water out (fig. 28).
- Place the iron back on the stand to cool down
(fig. 29).
- Set the 3-positions switch to the storage
position - (fig. 30).
The iron, the power unit and the stand are then
locked together.
- You can wind the cord around the stand. With
the cord clip you can fix the end of the cord
(fig. 31).
- Unlock the stand clamp (S) (fig. 32).
- Screw in the fixing screw completely (fig. 33).
- Fold the stand clamp into the stand (fig. 34).
- (Types HI 556/66 only:) First allow the iron to
cool down. Then place the carry case over the
stand.
Press onto the case to lock it to the stand
(“Click!”) (fig. 35).
27 28
29
30 31
32 33
34 35
CLICK