Harbor Freight Tools 3551 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. SKU 03551 03552
asseMbly
Mounting the body to your
Workbench
Select a place on your workbench to 1.
mount the Arbor Press.
Purchase hardware to mount your Arbor
2.
Press to your workbench. Bolt length
will be the thickness of your workbench
plus 2-1/2” of length for the Arbor Press
BODY (#1).
Body (#1)
Mounting Hole
Mounting Hole
(not shown)
Figure 1 -- Location of Mounting Holes
3. Use the two mounting holes in the BODY
of the Arbor Press as a template as
shown in Figure 1. Mark and Drill holes
in your workbench.
Place the BODY over the holes in the
4.
workbench and insert the bolts through
the holes. Thread on the nuts and
tighten.
arbor press assembly
Plate (#6)
Body (#1)
Spring Pin (#7)
(not shown)
Figure 2 -- Installing the Plate
1. Place the PLATE (#6) onto the Base of
the BODY (#1) as shown in Figure 2.
Insert the SPRING PIN (#7) into the hole
in the BODY.
Rack (#10)
Rack Teeth
Body (#1)
Cover (#8)
Figure 3 -- Installing the Rack
2. Insert the RACK (#10) down through the top
of the BODY as shown in Figure 3. Make
sure the teeth of the RACK are towards the
rear of the BODY as shown in the Figure.