Hustler Turf FASTRAK 60 - Manual (Page 18)

REV F 3-4 602900
Control Panel
When access is required under the seat platform and the seat
is equipped with the optional arm rests, make certain to place
the control arms in the park brake position and pivot the arm
rests upward before placing the seat platform in the full forward
position to prevent arm rest damage.
A. Deck clutch switch (Figure 3-1) — this switch engages
the deck. Pull the switch up to engage and push switch
down to disengage the clutch.
IMPORTANT: For additional clutch information refer
to the Mower deck operation section of this manual.
B. Ignition switch (Figure 3-1) — a three position switch:
“OFF”, “RUN”, and “START”. With key inserted, rotate
it clockwise to “START” position; release key when
engine starts, and switch will automatically return to the
RUN position.
C. Oil pressure light (Figure 3-1) — this light comes on
when the ignition switch is placed in the RUN position
and stays lit until the engine is running and a safe oil
pressure is developed. If light comes on during operation,
shut engine off immediately and locate and correct the
problem.
NOTE: The oil pressure light is not available on all
models.
D. Throttle control (Figure 3-1) — a cable is linked to the
engine throttle for controlling engine speed. Move lever
forward to increase engine rpm, move lever rearward to
decrease engine rpm.
E. Choke control (Figure 3-1) — a cable is linked to
manually operate the engine choke. When the lever is in
the down position, the choke is in the off (run) position.
When the knob is pulled up, the choke is in the on (start)
position. Do not operate the machine in the on (start)
position.
F. Electronic hour meter (Figure 3-1) — registers 1/10
hour increments up to 9,999.9 total hours. Connected to
the ignition switch, the meter records the accumulative
time while the ignition key is switched to the RUN
position.
G. 10 amp fuse (Figure 3-1) — Ignition system - 10 amp,
blade-type.
H. 20 amp fuse (Figure 3-1) — Safety system - 20 amp,
blade-type.
I. Fuel gauge (Figure 3-1) — This gauge shows the fuel
level for each fuel tank.
Controls
A. Steering control levers (Figure 3-2 & Figure 3-3) —
these levers control the mower’s speed, direction,
stopping, and park brake. These levers are used to steer,
accelerate, decelerate and change direction. When the
steering control levers are in the park brake position the
mower will not move when the engine is on and the drive
pumps are operating.
B. Deck lift pedal (Figure 3-4) — the deck lift pedal is used
to raise or lower the deck. Push on the pedal to raise the
deck and then place the deck height locking pin into the
desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
A. Deck clutch switch
B. Ignition switch
C. Oil pressure light
D. Throttle
E. Choke F. Hour meter
G. 10 amp fuse
H. 20 amp fuse
I.
Fuel gauge
Figure 3-1
E
H
G
C
A
B F
D
Units with single fuel tank
Units with dual fuel tanks
G
E
H
C A
B
F
D
I
WARNING
The parking brake may not hold the mower if parked on a
slope. Block or chock the machine when parked on a
slope.