Harbor Freight Tools 35149 - Manual (Page 8)

SKU 35149 For technical questions please call 1-800-444-3353. Page 8
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
V ~
Volts Alternating Current
A
Amperes
no
xxxx/min.
No Load Revolutions
Per Minute (RPM)
SYMBOLOGY
WARNING! The warnings, precautions, and instructions discussed in this manual cannot
cover all possible conditions and situations that may occur. The operator must understand
that common sense and caution are factors which cannot be built into this product, but
must be supplied by the operator.
Unpacking
When unpacking the 150 Watt Portable Clamp Light, check to make sure parts on page are
included. If any parts are missing or broken, please call
HARBOR FREIGHT TOOLS at
1-800-444-3353.
Assembly
Your Portable Clamp Light will require some minor assembly. The Light requires special conditions
for set up and operation. It is important that you read the entire manual to become familiar with the
product BEFORE you use the Portable Clamp Light. Before operating the Portable Clamp Light be
sure that you have all parts described in the Parts List and Assembly Diagram located on page 10
of this manual.
1. The Light comes with a Spring Clamp (1) and a hook, either of which can be used to hang
the Clamp Light. The hook can be turned to face up or down on the Spring Clamp as shown
in Figure 1.
Figure 1
Hook
Press here
to separate
clamp
Spring
Clamp (1)