Hampton Direct U32-LP2 - Manual (Page 14)

14 U32-2 FPI Direct Vent Gas Insert
HAMPTON CAST FACEPLATE
GRILL INSTALLATION
1) Install logs and flush glass before going on to the next step. See
manual for details.
3) The top louver, shown in diagram 1, is held in place by friction fit, if
the louver needs to be adjusted; bend the convex bracket out as
shown in diagram 2.
4) The bottom louver has 2 hinges that are attached
(2 screws per hinge) to the lip on bottom of the unit.
2) Before the grills are inserted onto the firebox, the U32 grill stop
bracket needs to be inserted in the bottom left corner just under the
firebox.
U32 Grill
Stop
Bracket
Note: The top and bottom grills and brackets
are different.
INSTALLATION
Note: The top louver should be placed with the
curved cut-out facing up.
Diagram 1
Diagram 2
Diagram 3
11) Mount the cast faceplate panels onto the insert body, sliding the
side filler brackets into the space between the glass and the
firebox. Secure using the 4 remaining black screws, 2 per side.
12) Install the glass trim by inserting the side hooks on the glass trim
into the 4 slots between the faceplate and the glass. Push the glass
trim down firmly with both hands to lock into place.
Slide side filler
bracket into gap
between glass and
fire box.
Side Hook
Slots
13) To put on the Hampton logo, peel the sticker from the back of the
logo and place it centered on the bottom left hand corner of the
faceplate.
Hampton Logo Left Hand
Side Faceplate