HONDA 08B26-S9V-100 User Manual
Page 8
8 of 8
All 23607 (0205)
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
21. Check that all wire harnesses are routed properly
and all connectors are plugged in.
22. Reinstall all removed parts.
23. Place shipping clips in a plastic bag and put the
bag in the glove box.
24. Reconnect the negative cable to the battery.
25. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
26. Start the engine. Push down on the driver’s
window switch until the window is fully open.
27. Pull up on the driver’s window switch to close the
window completely, then hold the switch for two
seconds.
28. Test the AUTO window function.
29. Do the idle learn procedure.
Make sure all electrical items are turned off.
Start the engine. Hold the engine speed at 3,000
rpm with no load (in Park or Neutral) until the
radiator fan comes on.
Let the engine idle for about 5 minutes with the
throttle fully closed and with all electrical items
off.
NOTE: If the radiator fan comes on during this step,
the time when it is operating must not be included in
the 5 minutes.
With Navigation Unit:
20. Slide the audio unit into the center panel opening,
and reinstall the four screws.
Without Navigation Unit:
AUDIO
UNIT
BUS CABLE
CONNECTOR
VEHICLE
CONNECTOR
ANTENNA
LEAD
SCREWS
(reused)
AUDIO
BRACKET
AUDIO UNIT
BUS
CABLE
VEHICLE
HARNESS
ANTENNA
LEAD
SCREW
(reused)
VEHICLE
HARNESS
HEATER
CONTROL