Fitting the loop handle, Assembling and dismantling the two-piece shaft, Assembly – Husqvarna 326C User Manual

Page 10: Dismantling, Fitting the trimmer head

Advertising
background image

10 –

English

ASSEMBLY

Fitting the loop handle

(326C)

Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.

Fit the screw, securing plate and wing nut as shown in the
diagram.

Tighten the wing nut.

Fitting the loop handle

(326L, 326LS, 326Lx, 326LDx)

Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.

Slide the spacer into the slot in the loop handle.

326L/326LS: Fit the nut, washer and screw.

326LX/326LDX: Fit the nut, knob and screw. Do not
overtighten.

Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.

Assembling and dismantling the
two-piece shaft

(326LDx)

Assembly:

Loosen the coupling by turning the knob.

Align the tab of the attachment (A) with the arrow on the
coupling (B).

Push the attachment into the coupling until the attachment
snaps into place.

Before using the unit, tighten the knob securely.

Dismantling:

Loosen the coupling by turning the knob (at least 3 times).

Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.

Fitting the trimmer head

A

B

!

WARNING!

When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.

!

WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.

C

Advertising
This manual is related to the following products: