Harbor Freight Tools Remote Control Stunt Car 66151 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. Item 66151
Installing Batteries
1. Remove the battery cover on
the back of the Remote.
2. Insert one 9-Volt battery (not included)
into battery compartment,
following indicated polarity.
3. Replace the Remote battery cover.
4. Turn the tabs out and remove the
battery compartment from the bottom
of the Stunt Car. See Figure A.
5. Insert four “AA” batteries (not included)
into the battery compartment,
following the indicated polarity.
CAUTION! Replace all batteries at
one time. Also, all batteries must be
of the same type and charge level.
Figure A
Battery
Compartment
Tab
Car
Switch
6. Slide the battery compartment
back into the Stunt Car.
7. Turn the tabs inward to lock the
battery compartment into place.
Operation
CAUTION! Keep all spectators a safe
distance away while during use.
Note: Take time to get familiar with the
controls of the Stunt Car in a location
that will be relatively safe for use.
Note: Read through this section
completely and get familiar with the
controls BEFORE using Stunt Car.
1. Extend the Antenna on the Remote.
Figure B
Throttle
(GO/BACK)
Steering
Remote
Switch
2. Turn Remote Switch on. The LED on
Remote will light. See Figure B, above.
3. Turn Car Switch on. See Figure A,
previous page. The LED lights
in the wheels will activate.
4. Place Stunt Car on floor
with wheels down.
5. To move Stunt Car forward, push
Throttle up. To move Stunt Car
backward, push Throttle down.
To increase speed, push Throttle farther.
8. Use the Steering control to
steer the Stunt Car.
9. To stop the Stunt Car,
release the Throttle.
10. If the Stunt Car rolls onto its
back, the small trick wheels will
allow it to continue moving.
11. After use, turn Car Switch off, then turn
Remote Switch off, and retract antenna.