Hitachi Koki USA DH 24PC - Manual (Page 15)

15
English
7. Using depth gauge (Fig. 14)
(1) Loosen the knob on the side handle,
and insert the depth gauge into the
mounting hole on the side handle.
(2) Adjust the depth gauge position ac-
cording to the depth of the hole and
tighten the knob bolt securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 15)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 15)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
(4) To remove the drill bit (taper shank),
insert the cotter into the slot of the taper
shank adaptor and strike the head of
the cotter with a manual hammer sup-
porting on the rests. (Fig. 16)
Grip
Fig. 13
Fig. 15
Drill Bit
Taper shank
Adaptor Front Cap
Grip
Knob on Side
Handle
Cotter
Rests
Taper Snank Adaptor
Fig. 16
Fig. 14
Mounting
Hole Depth
Gauge