Hoshizaki CUBELET ICEMAKER/DISPENSER DCM-750BAH-OS - Manual (Page 55)

55
8) Move the power switch to the "ON" position, then replace the panels in their correct
positions.
9) Turn on the power supply, then move the control switch to the "ICE" position to start the
automatic icemaking process.
6. Removal and Replacement of Gear Motor
) Move the control switch to the "DRAIN" position and drain all of the water from the
evaporator.
) After the water has stopped draining, move the control switch to the "OFF" position,
then turn off the power supply. Remove the front and top panels, then move the power
switch to the "OFF" position.
3) Remove the front cover of the storage bin. Remove spout B, then remove spout A.
See Fig. .
4) Remove the apron panel, then remove the left side panel.
5) Remove the evaporator strap.
6) Remove the evaporator assembly bolts securing the evaporator assembly to the gear
motor. Lift the evaporator assembly up slightly. See Fig. 3.
7) Disconnect the wiring from the gear motor, then remove the
gear motor bolts. Lift the gear motor from the drain pan.
8) Place the new gear motor in the drain pan.
9) Using the gear motor bolts and washers, secure the gear
motor.
0) Connect the gear motor wires.
) Lower the evaporator assembly down and
secure it to the gear motor.
) Replace the evaporator strap in its correct
position.
3) Replace spout A, spout B, and the front
cover of the storage bin in their correct
positions.
4) Move the power switch to the "ON"
position, then replace the panels in their
correct positions.
5) Turn on the power supply, then move the
control switch to the "ICE" position to start
the automatic icemaking process.
Fig. 3
Gear Motor
Evaporator
Assembly
Bolts
Drain Pan
Evaporator
Gear Motor Bolts