Home Automation 10A11-1 - Manual (Page 2)

Page 2
_
+
_
+
SPKR1 (SPEAKER #1 OUTPUT)
SPKR1 (SPEAKER #1 COMMON)
SPKR2 (SPEAKER #2 OUTPUT)
SPKR2 (SPEAKER #2 COMMON)
TWISTED PAIR
WITH SHIELD
TWISTED PAIR
TWISTED PAIR
8 OHM
SPEAKER
SPEAKER
8 OHM
MODEL 10A11-1, REV C
TWO-WAY AUDIO/VOICE ALARM MODULE
TWO-WIRE
ELECTRET
MICROPHONE
MICROPHONE
ELECTRET
TWO-WIRE
33A00-4 CONSOLE,
33A00-20 KEYPAD, OR
28A00-1, 28A00-2,
MIC2 (MICROPHONE #2 COMMON)
MIC1 (MICROPHONE #1 COMMON)
MIC2 (MICROPHONE #2 INPUT)
MIC1 (MICROPHONE #1 INPUT)
-
+
-
+
-
+
-
+
SPEAKERS / MICROPHONES
HI-FI
IN
PAGE
HI-FI
SOURCE 6
AUDIO IN
LINE OUT (LINE-LEVEL AUDIO OUTPUT)
PAGE OUT (PAGE OUTPUT)
PAGE OUT (PAGE OUTPUT)
Figure 1 - Speaker/Microphone Connections
MOUNTING
When mounting and connecting the Model 10A11-1, Rev C, power down the controller (AC and battery). Connecting the Model
10A11-1, Rev C board, while power is still applied to the controller, can damage the board, the controller, or both.
Mount the Model 10A11-1, Rev C to the upper right side of the enclosure using the supplied adhesive-backed resealable fasteners.
When connecting to an OmniLT, route the cable to the connector on the top of the board marked "J1". Plug the Model 10A11-1, Rev
C cable into "J1" on the controller. The red wire should be to the left of the connector (red wire to Pin 1) - See Figure 2.
Make sure that the connector is aligned with the pins on "J1".
When connecting to an Omni II, OmniPro II, Lumina, or Lumina Pro, route the cable along the top of the enclosure to the connector
on the left side marked "J2". Plug the Model 10A11-1, Rev C cable into "J2" on the controller. The red wire should be to the top of
the connector - See Figure 3. Make sure that the connector is aligned with the pins on "J2".