HP LTO 4 SAS - Manual (Page 14)

HP (HP-UX) servers and workstations 12
The lunpath hardware path for the above tape drive is
“0/4/1/0.0x50060b0000b7f3c8.0x0”.
• The FC bus ID is “0/4/1/0” (including all the numbers separated by “/”).
From the remaining “0x50060b0000b7f3c8.0x0” portion:
• Tape drive WWN (hexadecimal) = 0x50060b0000b7f3c8
• Tape drive SCSI LUN = 0x0 (hexadecimal SCSI-3 64-bit LUN identifier)
Adding stape and schgr (autoloader driver) to the kernel
For HP-UX 11i v1, 11i v2
If your tape drive or autoloader does not appear in ioscan listing or is listed with H/W Type
“UNKNOWN” you may need to install the appropriate drivers.
Use the ‘sam’ utility. Sam runs as a mouse driven GUI (
Figure 1 ) on a system with full graphics
capability, or as a console text-based interface ( Figure 2 ). If you use the text-based interface, use the
Tab and arrow keys to navigate, and the Return key to select.
Figure 1 SAM GUI