HP LTO 4 SAS - Manual (Page 9)

HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide 7
1 Introduction
Purpose of this manual
This manual provides basic information on configuring the drives with various operating systems.
See the top-level release notes that accompany the drive for expected functionality and features.
LTO Ultrium drives are supported on the following platforms:
• HP (HP-UX) servers and workstations ( Chapter 2 )
• HP (OpenVMS) servers and workstations ( Chapter 3 )
• HP (Tru64 5.1x) servers and workstations ( Chapter 4 )
• IBM (AIX) servers and workstations ( Chapter 6 )
• Linux (kernel 2.6.x) servers and workstations ( Chapter 5 )
• Sun (Solaris 8, 9, 10) servers and workstations ( Chapter 7 )
For platforms not mentioned here, contact HP because there may be new connectivity details
available that arrived after the release notes were published.
See
Chapter 8 on page 37 for details of how to verify the installation.
LTO Ultrium drives in a library
Although LTO Ultrium drives may also be used in a library, instructions about installing device
drivers for automatic robotics are not included in this manual.
SAS drives
SAS drives are only supported on Redhat and SLES Linux.
Backup applications
For optimum performance it is important to use a backup application that supports the drive’s
features within your system’s configuration.
For details of which backup applications are supported with your tape drive and system, visit the
HP Tape Compatibility website:
http://www.hp.com/products1/storage/compatibility/tapebackup/index.html
Follow the “Software compatibility” link then click a tick in the appropriate matrix to drill down into
detailed application support information.
See the Getting Started Guide for more information about usage models.