Honeywell CT3550 - Manual (Page 15)

15 69-1284—2
❑ Press or until the desired wake temperature displays.
The setpoint temperature range is 40°F to 90°F (4.5°C to 32°C) for heating and 45°F to 99°F (7°C to 37°C) for cooling.
❑ Press to switch between setpoints.
NOTE: Program times are the same for heating and cooling.
❑ Press or until the display shows the desired temperature setpoint.
❑ Press until the fan is at the desired setting (On or Auto).
NOTE: Setting Fan to On runs the system fan continuously in the program periods.
❑ Press , or and repeat these steps for each time period. Your weekday is now programmed.
Program Saturday and Sunday
❑ Repeat each step in Program Weekdays for Saturday and Sunday.
❑ Press when the entire week is programmed.
Clear a Program Period
NOTE: Wake cannot be cleared.
❑ Press , , or for the program period you want to clear.
❑ Press until the desired day displays (Mon-Fri Sat; Sun).
❑ Press and hold the , , or for approximately 3 seconds until the time and temperature clear.
❑ Repeat the above steps for each period to be cleared.
❑ Press .
Heat/Cool
Settings
Fan
Leave Return Sleep
Run
Program
Leave Return Sleep
Day
Leave Return Sleep
Run
Program