Heath Zenith SL-5656 - Manual

© 2007 HeathCo LLC 598-1331-00
1. Select a location on a flat wall with structurally sound wood
and from 10 to 25 feet (3 to 7.6 m) from the ground. The wood
should be at least one inch thick to safely secure the fixture.
2. Using the mounting template as a guide, mark the 3 mounting holes.
We suggest drilling 3/16" (4.8 mm) pilot holes for the lag screws.
3. Install the two bottom lag screws first. Screw in the lag screws
so that there is about 3/8" (9.5 mm) of space under the head.
4. Place the fixture on these two screws and install the top lag screw.
Tighten the top lag screw first, then tighten the remaining lag
screws.
5. Secure your outdoor cable or flexible conduit to the cover plate
with a fitting in accordance with the National Electrical Code
(Canadian Electrical Code in Canada).
6. Thread the black and white fixture wires through the hole in the
cover plate as shown.
7. Connect the fixture wires to the service wires (black to black
and white to white).
8. This fixture must be connected to ground. Secure the service
ground wire under the head of the green ground screw.
9. Install the cover plate. Secure with the two screws, washers, and
nuts provided.
10. Install the reflector/lens assembly. Secure with the two screws
provided.
11. Plug in the 70 watt compact fluorescent lamp provided (NEMA
designation CFTR70W/GX24Q with GX24Q-6 base).
Note: A 57 watt compact fluorescent lamp can also be used with
this fixture. The NEMA designation is CFTR57W/GX24Q with
GX24Q-5 base.
Installation Instructions
READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.
NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through
conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of
the system.
WARNING: Turn power off at the fuse or circuit
breaker.
Lamp in Fixture Contains Mercury. Dispose According
to Local, State, or Federal Laws.
Model SL-5656
Ground Screw
Photocontrol
Lens/Reflector
Assembly
Fixture Wires Thru
This Hole
Cover Plate
Compact Fluorescent Dusk-to-Dawn
70 Watt Security Light
CAUTION: Do not use any other wattage lamps
in this fixture.
ATTENTION: When removing, grasp bulb by the base. Do not
grasp glass bulb to remove.
To test operation during daylight, cover the photocontrol with black
electrical tape. Turn on the power. The light should come on immedi-
ately and will take up to ten minutes to reach full brightness. Uncover
the photocontrol and your unit will operate automatically—on at
dusk, off at dawn.