HP 3550 - Manual (Page 57)

Jam recovery
This option allows you to configure the printer response to paper jams, including how it
handles the pages involved. AUTO is the default value.
● AUTO. The printer automatically turns jam recovery on when sufficient memory is
available.
● ON. The printer reprints any page involved in a paper jam. Additional memory is
allocated to store the last few pages printed. This might cause overall printer
performance to suffer.
● OFF. The printer will not reprint any page that was involved in a paper jam. Since no
memory is used to store the most recent pages, performance might be optimal.
To set jam recovery response
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight JAM RECOVERY.
7. Press to select JAM RECOVERY.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
Language
The option to set the default language appears when the printer is turned on for the first
time. As you scroll through the available options, the list appears in the language that is
highlighted. When the list appears in the language desired, press to set the language. You
can also change the language at any time by performing the following procedures:
To select language
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight Language.
7. Press to select Language.
8. Press or to select the appropriate language.
9. Press to set the selection.
10. Press M
ENU
.
ENWW Changing printer control panel configuration settings 45