Hand Held Products IT3800 - Manual (Page 25)

IT3800/3900 User’s Guide 1 - 13
Nixdorf OCIA Interface
The Nixdorf OCIA bar code also programs the following prefixes for each
symbology:
Serial Wedge
The IT3800/3900 uses true and TTL signal levels to wedge into an RS-232 serial
network. Use IT3800/3900 serial wedge cables only to prevent damage to the
scanner. Refer to the serial interface programming (pages
2-8 to 2-12 ) to set the
baud rate and communications protocol.
To set up the serial wedge terminal ID, find the terminal ID in the Supported
Terminal Chart and follow the instructions on
page 2-2 . Set the port to which you
want the scanned data to transmit. Port 1 corresponds to P1 on the output cable
and Port 2 corresponds to P2 on the output cable. Choosing Both sends
scanned data to P1 and P2. Default = P1.
Symbology Prefix
EAN/UPC with Addenda 44 4B
Code 39 44 49
Interleaved 2 of 5 44 48
2 of 5 44 47
Code 128 44 4A
Nixdorf OCIA Interface
* P1
P2
Both P1 and P2