Multiple symbols, No read, Multiple symbols -12 no read -12 – Honeywell 3800gPDF User Manual
Page 48
3 - 12
3800g/3800gHD/3800gPDF User’s Guide
When the output sequence is
Off, the barcode data is output to the host as the
image scanner decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Multiple Symbols
When this programming selection is turned
On, it allows you to read multiple
symbols with a single pull of the imager’s trigger. If you press and hold the trig-
ger, aiming the imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The imager attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned
Off, the imager will only read the symbol closest to the aiming beam.
No Read
With No Read turned
On, the imager sends an “NR” to the host if you pull and
release the trigger without reading a code (e.g., bad bar code). If No Read is
turned
Off, the “NR” will not be sent to the host.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message using the
code for the No Read symbol is 9C.
Required
On/Not Required
*Off
On
* Off
On
* Off