Husqvarna 1055 GN - Manual (Page 10)

10 www.usa.husqvarna.com
A - 10 Volt AC, 0 Amp, Duplex Receptacles — May
be used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool, and motor loads.
B - 10/40 Volt AC, 30 Amp Locking Receptacle — May
be used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
C - Double Pole Circuit Breaker (AC) — A double pole
circuit breaker is provided to protect all the receptacles
and generator against electrical overload.
D - Fuel Valve — Used to turn fuel supply on and off to
engine.
E - Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
F - Data Tag — Provides model, revision, and serial number
of generator. Please have these readily available when
calling for assistance.
G - Choke Lever — Used when starting a cold engine.
H - Air Cleaner — Protects engine by filtering dust and
debris out of intake air.
J - Recoil Starter — Used to start the engine.
K - Oil Drain Plug — Drain engine oil here.
L - Rocker Switch — Set this switch to “On” before using
recoil starter. Set switch to “Off” to stop engine.
M - Oil Fill Cap — Check and fill engine with oil here.
N - Fuel Tank — Capacity of seven (7) U.S. gallons (26.5 L).
P - Spark Arrester Muffler — Exhaust muffler lowers engine
noise and is equipped with a spark arrester screen.
Items Not Shown:
Engine Identification — Provides model, type and code
of engine. Please have these readily available if calling for
assistance.
Features and Controls
Read this Operator’s Manual and safety rules before operating your generator.
Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
H
A
G
F
E
D
C
B
M
L
K
N
P
J