Havis-Shields Heavy Duty Trak Mount 2003-2006 Ford Expedition C-TM-EXPD - Manual

C-TM-EXPD-INST-2-07
INSTALL INSTRUCTIONS C-TM-EXPD
HEAVY DUTY TRAK MOUNT
2003-2006 FORD EXPEDITION
TOOLS REQUIRED:
Metric socket set
Standard socket set Ratcheting wrench
HARDWARE:
QTY DESCRIPTION PART
#
16 ¼-20 x 3/4” Hex Head Bolt GSM33001
8 ¼” Flat Washer GSM31005
8 ¼” Lock washer GSM31026
8 ¼” Serrated nut GSM30023
1 Front transmission hump bracket C-B35
1 Rear transmission hump bracket C-B36
1 32” Trak Mount C-TM-32E
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
INSTALLATION:
1. Remove O.E.M. console if applicable.
2. Remove inner front and rear seat-
mounting bolts near transmission hump.
Loosen outer bolts only.
3. Place front and rear hump brackets legs
in place under seat brackets. Do not bolt
down.
4. Position cross piece and trak mount on
top of legs.
5. Determine best position for application.
6. Attach trak to cross pieces using ¼” x
¾” hex bolts and serrated nuts.
7. Attach trak and cross piece assembly to
mounting legs using ¼” x ¾” bolts and
washers.
8. Tighten all seat bolts
9. Attach console and/or accessories.
Rear
Front