Home Automation 38A14-1 - Manual (Page 2)

BATTERY INSTALLATION
The Model 38A14-1 requires one CR2025 lithium button cell battery (included). To install or replace the battery, remove the Battery
Holder as indicated below:
1) Insert a paper clip or small-bladed screwdriver into the Battery Release slot and shift the latch to the right while sliding the
Battery Holder from the battery compartment.
Battery
Release
Battery
Holder
+
CR2025
2) Flip the Battery Holder over and insert the battery observing proper polarity.
3) Insert the Battery holder into the battery compartment and snap into place.
OPERATION
To control a Model 38A00-1 Scene Switch with IR Receiver:
a) Press the appropriate Room button on the Remote Control that corresponds with the Scene Switch that you intend to control.
b) From within 25 feet, press the desired buttons on the Remote Control to simulate pressing the pushbuttons on the Scene Switch.
c) Press a different Room button on the Remote Control that corresponds with different Scene Switch that you intend to control.
d) From within 25 feet, press the desired buttons on the Remote Control to simulate pressing the pushbuttons on the Scene Switch.
Note: The Remote Control must be within 25 feet and aimed directly at the Scene Switch you intend to control for the
transmission to succeed. Any object in the direct line-of-sight of the Remote Control and Scene Switch may cause the signal to
be unsuccessful.
1