HONDA 31SAA610 - Manual (Page 212)

Disconnect the blade assembly
from the wiper arm:
Press and hold the lock tab.
Slide the blade assembly toward
the lock tab until it releases
from the wiper arm.
When replacing a wiper blade,
make sure not to drop the wiper
blade or wiper arm down on the
windshield.
Examine the new wiper blades. If
they have no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the new
blade. Remove the blade from its holder
by grasping the tabbed end of the
blade. Pull firmly until the tabs
come out of the holder.
Make sure the three rubber tabs
inside the blade fit to each notch
of the reinforcement, as shown.
2. 3. 4.
Wiper Blades
206
LOCK TAB
BLADE
REINFORCEMENT
BLADE
TOP