Hitachi POWER TOOLS CR 13VA - Manual (Page 22)

--- 20 ---
Fig. 13-a
2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to following items.
(1) Press-fitting the Recipro Plate [61] ass'y into Second Shaft (A) [64] (Fig.13)
Tool required: Special repair tool J-315
Mount the two Ball Bearings 6003VVCMPS2L [62] and the Retaining Ring for D35 Hole [63] to the Recipro
Plate [61] to complete the assembly (recipro plate ass'y).
(a) If the Gear [65] and the Ball Bearing 608VVC2PS2L [66] are not mounted to Second Shaft (A) [64],
mount Second Shaft (A) [64] and the recipro plate ass'y to the special repair tool J-315 and press-fit it in
the direction of the arrow with a hand press as shown in Fig. 13-a.
(b) When the Gear [65] and the Ball Bearing 608VVC2PS2L [66] are mounted to Second Shaft (A) [64],
mount Second Shaft (A) [64] and the recipro plate ass'y to the special repair tool J-315 and press-fit it in
the direction of the arrow with a hand press as shown in Fig. 13-b.
Be careful of the direction when press-fitting the recipro plate ass'y.
(2) Press-fitting Metal (A) [8] into the guide sleeve (Fig. 14)
(Metal (A) [8] and the guide sleeve are supplied together as
the Guide Sleeve Ass'y [9].)
Tool required: Special repair tool J-316 (adjusted to the
proper dimensions)
Insert Metal (A) [8] into the press-fitting portion of the guide
sleeve so that the outer flat section of the metal can be seen
from the 8 mm dia. hole of the guide sleeve. (An inspection
hole is provided on one side of the metal.) Mount the two
special repair tools J-316 in the 8 mm dia. hole as shown in
Fig. 14. Push the guide sleeve in the direction shown by the
arrow as far as it will go with a hand press.
Fig. 14
Fig. 13-b
J-315
J-315
J-315
J-315
J-316
Guide sleeve
J-316
J-316
8 mm dia. hole 8 mm dia. hole