Hitachi 55HDS69 - Manual (Page 5)

Securing to a table-top
1.
Using wood screws (two) fasten the set to the
clamping screw holes on the rear of the Plasma
TV stand as shown below.
2. Using commercially available wood screws, secure
the set firmly in position.
Securing to a Wall
1.
Keep the Plasma television 4 inches away from the
wall except when mounted using the wall mount
bracket.
2. Secure the television to the wall as shown .
NOTES: 1.
Do not block the ventilation holes of
the Plasma Television. Blocking
the ventilation holes might cause fire
or defect.
2.
In case of an abnormal symptom,
unplug the AC cord.
3
. If you purchased the wall mount
bracket option, please ask for
professional installer. Do not install
by yourself.
4.
Install the unit at a proper area where
it does not expose anyone to any to the
danger of hitting themselves (for example
their hands, head or face, etc.) against
the edge of the unit and cause personal
Caution when moving the main unit
As this product is heavy, whenever it is moved, two
people are required to transport it safely. Whenever the
unit is moved it should be lifted forward using the top
and base on both sides of the Television for stability.
When moving the Television, lift the handles (42”
models), support the top frame (55” models) and the
bottom frame as shown below.
ANTENNA
Unless your Plasma Television is connected to a cable
TV system or to a centralized antenna system, a good
outdoor color TV antenna is recommended for best
performance. However, if you are located in an
exceptionally good signal area that is free from
interference and multiple image ghosts,
an indoor antenna may be sufficient.
LOCATION
Select an area where sunlight or bright indoor
illumination will not fall directly on the picture screen.
Also, be sure that the location selected allows a free
flow of air to and from the perforated back cover of the
set. In order to prevent an internal temperature
increase, maintain a space of 10 cm (4 inches) from the
sides/back of the Television, and 30 cm (12 inches)
from the top of the television to the wall. To avoid
cabinet warping, cabinet color changes, and increased
chance of set failure, do not place the TV where
temperatures can become excessively hot, for
example, in direct sunlight or near a heating appliance,
etc.
TURNING RADIUS
The maximum turning radius is 30 (left and right). Do
not place any objects on the path of the TV when turning
the panel.
NOTE: The Table Top Stand
for model 55HDS69 is
not included (Optional).
To take measures to prevent the Plasma Television from tipping over and prevent possible injury
it is important to mount the unit in a stable and flat surface.
5
First time use
How To Set Up Your New Hitachi Plasma Television
30 cm (12 inches)
10 cm (4 inches) 10 cm (4 inches)
C
D
A
Fixing point
* Please adjust the wire length to avoid
touching the wall when turning the TV.
Wood screw
two places
Wire
42” 55”
26.9 cm 35.4 cm
38.1 cm 42.8 cm
10.59 in. 13.93 in.
15 in. 16.85 in.
injury.