HONDA WMP20X - Manual (Page 8)

8
ENGINE MAINTENANCE
Engine Oil Level Check
Check the engine oil level with the engine stopped and in a level
position.
1. Remove the filler cap/dipstick and wipe it clean.
2. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
3. If the oil level is low, fill to the edge of the oil filler hole with the
recommended oil.
4. Screw in the filler cap/dipstick securely.
NOTICE
Running the engine with a low oil level can cause engine damage.
Engine Oil Change
Drain the oil while the engine is warm. Warm oil drains quickly and
completely.
1. Remove the oil
filler cap, drain
plug, and sealing
washer. Drain the
oil into a suitable
container.
2. Reinstall the drain
plug and sealing
washer. Tighten
the plug securely.
Please dispose of
used motor oil and
the oil containers in
a manner that is
compatible with the
environment. We
suggest you take
used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash or pour it on the ground or
pour it down a drain.
3. Fill with the
recommended oil to
the top of the oil
filler neck.
4. Screw in the oil filler
cap securely.
Engine Oil Recommendations
Oil is a major factor affecting performance and service life. Use
4-stroke automotive detergent oil.
SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the recommended range.
The SAE oil viscosity and service category are in the API label on the
oil container. Honda recommends that you use API SERVICE
category SJ or later oil with the ILSAC “starburst” certification mark
displayed on the container.
NOTICE
Using nondetergent oil can shorten the engine's service life, and using
2-stroke oil can damage the engine.
FILLER CAP/DIP
STICK
UPPER LIMIT
LOWER LIMIT
SEALING WASHER
DRAIN PLUG
FILLER
CAP
OIL
FILLER
CAP
TOP OF
OIL FILLER NECK
AMBIENT TEMPERATURE
5W-30 • 10W-30
30
POM50594-G_WMP20X.fm Page 8 Tuesday, March 25, 2008 2:34 PM