Harman-Kardon II - Manual (Page 8)

For Wall-Mounting
Note: The customer is responsible for the correct selection and use
of mounting hardware (available through hardware stores) that will
ensure the proper and safe wall-mounting of the speakers.
1. Remove the Modulus II from its box. Remove rubber cover from
base and pull out Allen wrench. Use Allen wrench to remove
mounting plate screw and remove mounting plate from base.
2. Secure the mounting plate to a wall stud using (4) #8-32
wood screws with a minimum 1-1/4" length. If fastened to
wallboard with a minimum 1/2" depth, use #8 screws with
plastic inserts or anchors. Do not mount directly to wallboard
without plastic inserts or anchors designed for #8 screws.
One of the mounting plates in the Modulus II system has a
built-in bubble level. This mounting plate should be used as a
template for mounting the mounting plates that do not include
a bubble level.
2a. In cases where you would like to run the speaker wires through
the wall, the mounting plate has a center hole for wire access.
3. Run speaker wires through base as shown below. Attach base
to mounting plate by slipping the returns on underside of base
into slots on the top of the mounting plate and hinging the base
downward. Secure base by inserting and tightening mounting plate
screw.Tighten adjustment screw, fixing the speaker into position.
4. Insert the Allen wrench back into holder in base and attach
rubber cover.
4 MODULUS II HOME THEATER SYSTEM
Adjustment
Screw
Allen Wrench
Housed
in Base
Rubber
Cover
Mounting Plate Screw
Base
Speaker
Mounting Plate
Speaker Wires
Hole in the Wall
WALL Bubble Level
Viewed From Below Note: Base Has Returns
That Grab Mounting Plate
Returns on
Underside of Base
Rubber Cover
Speaker Wires
Adjustment Screw
Allen Wrench
F IGURE 7
F IGURE 8
F IGURE 9
#8-32 Wood
Screws (Not
Included)