HONDA AM/FM CD TUNER POCKET ATTACHMENT KIT User Manual
Page 2
2 of 3
AII 24298 (0212)
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
1.
Wrap a shop towel around the top of a flat-tip
screwdriver and insert it into the grooves of the
audio panel. Pull the audio panel out toward you to
release the five clips and remove the audio panel.
Take care not to damage the clips and the audio
panel. Disconnect the antenna lead and the 20-pin
connector from the rear of the cover.
3.
Push the front of the pocket from above and below
and hold for one minute to fix the shape.
4.
Position the audio unit on the pocket and install
the two brackets with the four 5 x 8 mm washer-
bolts and two 4 x 12 mm self-tapping screws.
2.
Remove and discard the cover from the audio
panel (four tabs).
2008060K
PUSHDOWN
PUSHUP
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
INSTALLATION
2828202K
GROOVES IN
AUDIO PANEL
CLIPS (5)
AUDIO
PANEL
COVER
ANTENNA
LEAD
VEHICLE 20-PIN
CONNECTOR
FLAT-TIP
SCREWDRIVER
2018030K
RETAINING
TAB
COVER
(Not reused.)
RETAINING
TAB
AUDIO
PANEL
2625021K
AUDIO
UNIT
5 x 8 mm
WASHER-
SCREW
4 x 12 mm
SELF-
TAPPING
SCREW
Insert the
boss on the
pocket with
this hole.
Use the
upper hole.
5 x 8 mm
WASHER-
SCREW
4 x 12 mm
SELF-
TAPPING
SCREW
Use the
lower
hole
BRACKET
"R"
BRACKET
"L"
Tighten with a screw
while pushing the
front of the pocket in
upward direction.