Homelite MIGHTYLITE UT50901 - Manual (Page 11)

Page 11
To start a warm engine:

Slowly press the primer bulb seven (7) times.
 Pull the starter grip sharply until the engine runs.
TO STOP THE ENGINE:
See Figure .
Release the throttle trigger and push
STOP on the ON/OFF
switch.
IF ASSISTANCE IS REqUIRED STARTING THIS
PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-242-4672
USING THE EDGER
See Figure .
When using the edger, hold the unit with your right hand on
the rear handle and your left hand on the front handle. Keep
a firm grip with both hands while in operation. The edger
should be held at a comfortable position with the motor
about hip height.
NOTE: Always operate at full throttle. Prolonged cutting
at partial throttle will result in lubricant dripping from the
muffler.
OPERATING TIPS
 The edger will edge along sidewalks, driveways, flower
beds, curbs, and similar areas.
 Use the arrow guide on the blade guard to align the blade
with the edging surface.
 Cut at a steady pace. If the blade begins to bog down,
you are edging too fast; slow your pace. Do not force the
blade into the ground.
 Light contact of the blade against the sidewalk edge, curb,
etc., is acceptable and will not damage the edger.
 Best appearance is obtained when grass is dry. Avoid
edging in wet soil or wet grass areas or the blade guard
might clog and result in an uneven edge. If the blade guard
becomes clogged, stop the engine, disconnect the spark
plug wire and move it away from spark plug, and remove
debris from the blade guard.
OPERATION
Fig. 5
PRIMER
BULB
Fig. 6
cHOkE
DIAL
STARTER
GRIP
ARROw GUIDE