Honeywell HZ-2300 - Manual (Page 4)

ILLATION FEATURE
To use this feature, slide the Oscillation switch located at the bottom of the heater to
ON. The heater will then oscillate 45° to each side.
FAN OPERATION
• This heater is equipped with a “tip over switch” safety feature which automatically
shuts off heating element if heater is not in an upright position. Heat will resume
once heater is properly oriented.
• This heater is equipped with an internal High limit Switch which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
To use the unit as an air circulator without heat, turn the selector knob
to FAN and the thermostat to its highest setting.
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstruction. If you find an obstruction turn the heater OFF.
Unplug the heater and wait at least ten minutes for it to cool. Carefully remove the
obstruction. Plug the heater back in and restart it as described under
OPERATION.
• Check that the thermostat is not set too low. With the selector knob set to a heat
setting, turn the thermostat up (clockwise) until the heater restarts.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER,
PLEASE SEE THE WARRANTY FOR INSTRUCTIONS. PLEASE DO NOT
ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO
MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR
PERSONAL INJURY. IF THE PROBLEM STILL
PERSISTS, PLEASE CALL:
Kaz Home Environment Mail questions or comments to:
CONSUMER RELATIONS DEPARTMENT Kaz Home Environment
TOLL FREE: 1-800-332-1110 Consumer Relations Dept.
E-mail: [email protected] 250 Turnpike Road
Southborough, MA 01772 U.S.A.
Please be sure to specify model number.
OSCILLATION FEATURE
FAN OPERATION
OTHER FEATURES
IF YOUR HEATER FAILS TO OPERATE: